if the equilibrium constant for a b c is 0.208, then the equilibrium constant for 2c 2a 2b is a.4.81 b.0.416 c.23.1 d.0.584 e.0.208

Answer:

I believe its oxygen gas  

Explanation: The density of a gas is 1.43 g/L

The behavior of acid chlorides is different from that of aldehydes in a reaction with a nucleophile because acid chlorides are more reactive and have a better leaving group than aldehydes.

In acid chlorides, the carbonyl carbon is bonded to a chlorine atom, which is a good leaving group due to its high electronegativity and ability to stabilize a negative charge when it leaves. This makes acid chlorides more susceptible to nucleophilic attack, resulting in faster reactions with nucleophiles.

In contrast, aldehydes have a carbonyl carbon bonded to a hydrogen atom, which is not a good leaving group. As a result, aldehydes are less reactive towards nucleophiles compared to acid chlorides.

In summary, the difference in reactivity between acid chlorides and aldehydes in a reaction with a nucleophile is due to the presence of a better leaving group in acid chlorides, which makes them more reactive than aldehydes.

To know more about aldehydes refer here:

https://brainly.com/question/31593671#

#SPJ11

Answer:

Organic waste in landfills generates, methane, a potent greenhouse gas. By composting wasted food and other organics, methane emissions are significantly reduced. Compost reduces and in some cases eliminates the need for chemical fertilizers. Compost promotes higher yields of agricultural crops.

Explanation:

The first step of the reaction, we have  reaction between a nucleophile and an electrophile.

We can see that in the first step of the reaction, we have  reaction between a nucleophile and an electrophile. In this case, the electrophile would have to be an alkyl halide which produces a carbocation as show in the image attached. What we have here is quite similar or  like most of the organic reactions, this reaction occurs in a number of detailed or smaller steps and each step of the reaction is going to help to bring us closer to the end product of the entire steps of the reaction which is wat we target as we carry out the particular reaction.The second step involves the reduction of the alkyne with the use of a Lindlar catalyst. As such the reaction is poisoned and it stops at the alkyne stage rather than going on to obtain the alkane.

Learn more about electrophile here:

https://brainly.com/question/21773561

#SPJ4

Answer:

14.007 amu

Explanation:

N-15 has 15 amu, while N-14 has 14 amu.

So average isotope mass = 15(0.7%) + 14(99.3%)

= 15(0.007) + 14(0.993)

= 0.105 + 13.902

= 14.007 amu

When an unknown metal M reacts with sulfur to form a compund M2S3.If 3.12g of M reacts with 2.88g of Sulfur, the name of M chromium and M2S3 will be chromium(III) sulfide.

Let M be its atomic weight.

2M + 3S → M2S3

2:3 Molar ratio

3* 32.056g of S + 2M g of M

2M/(3*32.056) g will react with 1.000 g of S

 [2M/(3*32.056)]

*2.88 g of M and 2.88 g of S will react.

Assuming that this is 3.12 g

3.12 = [2M/(3*32.056)]

2.88 = 0.05990M

Chromium is present since M= 52.1 g and S= 32.0 at wt result in M= 52.0. At Wt = 51.996

Chromium(III) sulfide is the chemical's name.

Learn more about atomic weight on;

brainly.com/question/338808

#SPJ4

The pH of the solution after 15.00 mL of acid have been added to the ammonia solution is 5.63.

25.0 mL of 1.00 M ammonia (NH3) solution is titrated with 0.15 M HCl. After 15.00 mL of acid have been added to the ammonia solution, the pH of the solution can be calculated using the Henderson-Hasselbalch equation. The pH of the solution is 5.63.

The Henderson-Hasselbalch equation can be depicted as follows-

pH = pKb + log10([NH3]/[NH4+]).

In this equation, pKb = -log10(Kb) = -log10(1.8 x 10-5) = 4.74.

[NH3] = 1.00 M  and [NH4+] = 0.15 M.

Substituting these values into the Henderson-Hasselbalch equation, we get pH = 4.74 + log10((1.00/0.15)) = 5.63.

Therefore, the pH of the solution after 15.00 mL of acid have been added to the ammonia solution is 5.63.

To know more about ammonium solution refer here:

https://brainly.com/question/2671989

#SPJ4

Cesium Sulfite Chemical Formula:

Cs2SO3

Answer:

I think it will be the answer

2.5 x 10-2 mol

I hope it help you

Answer:

Chemical bonding - a mutual adhesion of atoms in an molecule and the crystal lattice.

Explanation:

Answer:

A chemical bond is a lasting attraction between atoms, ions or molecules that enables the formation of chemical compounds. The bond may result from the electrostatic force of attraction between oppositely charged ions as in ionic bonds or through the sharing of electrons as in covalent bonds.

The last third-party candidate to win one or more states was George Wallace of the American Independent Party in 1968.

Who was George Wallace?

To know more about George Wallace, click the link given below:

https://brainly.com/question/480072

#SPJ4

Explanation:

proton number and neutron number sums up to form the mass number

Answer:

Neutrons & protons

Explanation:

hope it's help..

Answer:

Normally, it explains that matter cannot be created or destroyed. It demonstrates different chemical reactions that help show the different transformations of the matter but will never destroy it or create it.

With water that is also at room temperature, a copper pot is filled. Imagine a scenario in which the pot gets hot and the water freezes on its own. This would be a violation of the second rule of thermodynamics.

The group of physical parameters that constitute thermodynamic systems in thermodynamic equilibrium includes temperature, energy, and entropy. These parameters are defined by the rules of thermodynamics. In addition, the laws use other thermodynamic process characteristics, such as thermodynamic work and heat, and they form correlations between them. They present empirical data that serves as a foundation for ruling out the existence of particular phenomena, such perpetual motion. They are crucial fundamental rules of physics that are applicable to other natural sciences and are used in thermodynamics in addition to being used there.

The first law, the second law, and the third law have historically been recognized as the three fundamental laws of thermodynamics.

Learn more about thermodynamics here:

https://brainly.com/question/1604031

#SPJ4

Yes, More heat speeds up the dissolving reaction by supplying energy to break bonds in the solid. This is the most prevalent case in which an increase in temperature causes an increase in solid solubility.

As the temperature of the solution rises, so does the average kinetic energy of the solute molecules. As a result, the molecules are less able to stick together and disintegrate more easily. As a result, increasing the temperature increases the solubility of solid states.

Solute and solvent crystal structures must be identical. When the solvent and solute have the same valency, complete solubility occurs. A metal with a higher valency is more likely to dissolve a metal with a lower valency. The electronegativity of the solute and solvent should be comparable.

To know more about solubility visit:

https://brainly.com/question/28170449

#SPJ4

Answer:

2KClO3 ---2KCl + 3O2

2NaCl + F2 ----> 2NaF + Cl2

2AlBr3 + 3 K2SO4 ----> 6 KBr + Al2(SO4)3

Explanation:

here's the answer to your question

13.41 moles are present in 2.20 kg of sodium phosphate.

A mole is defined as 6.02214076 × \(10^{23}\)of some chemical unit, be it atoms, molecules, ions, or others. The mole is a convenient unit to use because of the great number of atoms, molecules, or others in any substance.

The molar mass of sodium phosphate is 163.94 g/mol.

2.20 kg = 2200g

\(Moles = \frac{2200g}{163.94 g/mol.}\)

Moles = 13.41954374 = 13.41 moles

Hence, 13.41 moles are present in 2.20 kg of sodium phosphate.

Learn more about moles here:

https://brainly.com/question/8455949

#SPJ2

Answer: Boron is the element which has properties of both metals and nonmetals.

Explanation:

Metals are defined as the elements which loose electrons to attain stable electronic configuration. They attain positive charge and form cation. Example: Zinc (Zn), Aluminium (Al) , copper (Cu)

Non-metals are defined as the elements which gain electrons to attain stable electronic configuration. They attain negative charge and form anion. Example: Chlorine (Cl) , Sulphur (S)

Metalloids are defined as the elements which show properties of both metals and non-metals. There are 7 metalloids in the periodic table. They are Boron (B) , Silicon (Si) , Germanium (Ge) , Arsenic (As) ,  Antimony (Sb), Tellurium (Te) and Polonium (Po).

Thus boron is the element which has properties of both metals and nonmetals.

Answer:

The answer is A boron!!!!!!

Explanation:

i took the quiz on ed

Answer: Groups

Explanation:

I took the quiz

what is Maximum possible products?

Although Minimum Viable Product strategies are effective for startups, they presuppose you have no limitations. However, in an MPP universe, your limitations serve to focus you rather than to thwart you. Instead than conceptualizing ideas for the future, they require you to consider how well you can meet your clients' wants inside a specific situation that now exists.

Photobox will introduce countless new product lines that are only modifications of current products. For instance, a bowl could be printed as a dog bowl or a cereal dish for kids. The tech stack doesn't need to be altered, and customization yields the highest return on investment for the product.

Learn more about Maximum possible products visit here:-

https://brainly.com/question/26567900?referrer=searchResults

#SPJ4

Answer:

the number of atoms stays the same as the atoms lose energy to the colder freezer, slow down, get closer together, shrinking the volume

Explanation:

When a liquid is cooled, the average energy of the molecules decreases. At some point, the amount of heat removed is great enough that the attractive forces between molecules draw the molecules close together, and the liquid freezes to a solid.

I hope it helps.

Answer:

Sulfur (in British English: sulphur) is a chemical element with the symbol S and atomic number 16. It is abundant, multivalent and nonmetallic. Under normal conditions, sulfur

All of the listed options could potentially cause the molar mass calculated from freezing-point depression data to be greater than the true molar mass.

Accurately calculating the molar mass of a substance is essential for many scientific experiments and processes. One method for doing this is by using freezing-point depression data. However, there are various factors that could lead to an inaccurate molar mass calculation when using this method. This includes:

All of these could cause the molar mass calculated from freezing-point depression data to be greater than the true molar mass.

Learn more about molar mass at: https://brainly.com/question/837939

#SPJ4

Answer:

Both A and B

Explanation:

With hazardous materials, it is usually a safe bet that all of the listed precautions are required, so to protect hazardous materials.

Answer: A

Explanation: A

Scientists estimate that a single chlorine molecule in the CFC structure can destroy as many as 100,000 ozone molecules. So The correct answer is 100,000.

CFCs are fully halogenated paraffin hydrocarbons that contain only carbon, chlorine, and fluorine atoms. These organic compounds were discovered by scientists in 1928 and were initially used as a refrigerant, solvents, and aerosol propellants.

CFCs are known to be the primary cause of the depletion of the ozone layer. When these chemicals are exposed to ultraviolet light, they break down and release chlorine atoms. The chlorine atoms then react with ozone molecules, resulting in the destruction of the ozone layer.

Ozone is critical to the Earth's atmosphere because it helps protect it from the sun's harmful ultraviolet radiation. Ozone depletion exposes the planet to harmful UV radiation, which has been linked to skin cancer, cataracts, and other health problems.

To know more about chlorine molecule please refer to:

https://brainly.com/question/20485611

#SPJ11