Why the sulphides precipitate of group IIA should be washed with distilled water and then centrifuged before addition of dilution solution of HNO3?

Transition Metals is more often used to conduct electricity. Transition metals have free electrons in outer energy levels because d-orbitals shields poorly. That's why transition metals are good conductor of heat and electricity.

Transition metals are similar to main group metals in many ways, including their metallic appearance, malleability and ductility, ability to conduct heat and electricity, and ability to form positive ions.

In the periodic table, transition metals are found between s-block and p-block elements. D-block elements is the name given to them. A family of metals that display instability and transitional behavior between s block and p block elements are referred to as "transition metals."

To know more about transition metals visit:

https://brainly.com/question/14516782

#SPJ1

The fact that hydrogen peroxide slowly decomposes over time without the addition of any other chemical indicates that the hydrogen peroxide solution that can be purchased in stores is not pure and has been stabilized with other chemicals to prevent it from breaking down too quickly. This is common practice, as pure hydrogen peroxide is unstable and can be dangerous to handle.

One potential safety hazard associated with hydrogen peroxide solutions that have been stabilized with other chemicals is that they can sometimes release oxygen gas when they come into contact with other substances. This can cause the solution to bubble and froth, which can make it difficult to measure and handle safely. In extreme cases, the release of oxygen gas can cause the solution to become pressurized and explode. It is important to handle hydrogen peroxide solutions with care and to follow the instructions on the label to avoid potential hazards.

Answer: answer what..

Answer:

evan..

Explanation:

Answer:

The name of the game law used is called the Charles Law

Answer:

46.15

Explanation:

The mass of the percent of the 10 g solute in the 105 g solvent is 8.69 %.

The mass of the solute = 10 g

The mass of the solvent = 105 g

The mass of the solution = 10 g + 105 g

The mass of the solution = 115 g

The mass of the percent is expressed as :

The mass of percent = ( mass of solute / mass of solution ) × 100 %

The mass of solute = 10 g

The mass of solution = 115 g

The mass of percent = ( 10 / 115 ) × 100 %

The mass of percent = 8.69 %

Thus, the mass of percent is 8.69 % and the mass of solute is 10 and the mass of the solution is 115 g.

To learn more about mass of percent here

https://brainly.com/question/30742204

#SPJ1

In paragraphs 11-16 of "Miss Brill," Mansfield includes the scene in which a young couple joins Miss Brill on her special bench and the significance of this scene includes the following:

In this scene, we can see Miss Brill having a good time in the park but coming to realize soon enough that the couple who she admired and planned to listen to did not think kindly of her. This made the woman sad even as she walked down to her home.

Her sense of importance was dealt a blow in this case. In this story also, Miss Brill applied her ability to envision a joyful scene.

Learn more about "Miss Brill," by Mansfield here:

https://brainly.com/question/27929142

#SPJ1

Answer:

a.

Explanation:

electromagnetism

The decomposition of aspirin (acetylsalicylic acid,\(C_{9} H_{8} O_{4}\)) can occur through the hydrolysis reaction, resulting in the formation of acetic acid (\(CH_{3} COOH\)) and salicylic acid (\(C_{7} H_{6}O_{3}\)).

The decomposition of aspirin (acetylsalicylic acid, \(C_{9} H_{8} O_{4}\)) can occur through the hydrolysis reaction, resulting in the formation of acetic acid (\(CH_{3} COOH\)) and salicylic acid (\(C_{7} H_{6}O_{3}\)). To determine the moles of each product formed, we need to consider the balanced chemical equation for the reaction:

\(C_{9} H_{8} O_{4} = > C_{7} H_{6}O_{3} +CH_{3} COOH\)

From the equation, we can see that for every 1 mole of aspirin, 1 mole of salicylic acid and 1 mole of acetic acid are produced.

Therefore, the moles of salicylic acid and acetic acid formed will be equal to the number of moles of aspirin that decomposes. If we know the amount of aspirin in moles, we can directly calculate the moles of each product based on stoichiometry.

For more question on aspirin

https://brainly.com/question/25794846

#SPJ8

The comparison of H1 H2 and H3 tags is that:

There are a lot of  different HTML headings and they are:  H2 and H3, H4, H5, H6, etc.

The use of H1 tags is said to be the one that is often used to show all that a person will get if they click on the title. It is seen as the main keywords that will appear in a sequence to bring in one's target audience.

Therefore, The comparison of H1 H2 and H3 tags is that:

Learn more about tags from

https://brainly.com/question/26294460

#SPJ1

The net ionic equation for chemical reaction when  excess of hydroiodic acid combines with  sodium sulfite is 2 H\(^+\)  \(_(aq)\) + S\(^2-\)\(_(aq)\)\(\rightarrow\) H₂S\(_(g)\).

Ionic equation is defined as a chemical equation which represents electrolytes in aqueous solutions and are expressed as dissociated ions. Ions present in aqueous solutions are stabilized by ion dipole interactions with the water molecules which are present.

An ionic equation can be written for any electrolyte which dissociates and reacts with the polar solvent. In a balanced ionic equation , number and type of atoms on each sides of reaction arrow are same. Even the net charge on both sides of the arrow is same.

Strong acids and bases exist as dissociated ions present in the solution and are written in forms of ions in ionic equation.Weak acids and bases do not dissociate completely and hence are written in the form of molecular formula.

For the given reaction, net ionic equation is obtained as,by balancing the reaction between hydroiodic acid and sodium sulfite and then writing its dissociated form,

2 H\(^+\)\(_(aq)\) + 2 I\(^-\)\(_(aq)\) +2 Na \(^+_(aq)\) + S\(^2- _(aq)\rightarrow\) H₂S\(_(g) + 2 Na ^+ _(aq)\) +2 I\(^-_(aq)\)

Removing the spectator ions , final net ionic equation is,2 H\(^+\)  \(_(aq)\) + S\(^2-\)\(_(aq)\)\(\rightarrow\) H₂S\(_(g)\).

Learn more about ionic equation,here:

https://brainly.com/question/15466794

#SPJ1

Answer:  An electrochemical cell that produces electricity from a spontaneous oxidation-reduction reaction

Explanation:

Galvanic cell is a device which is used for the conversion of the chemical energy produced in a redox reaction into the electrical energy.

Galvanic cell consists of two half cells known as anode and cathode. Oxidation takes place at anode and reduction takes place at cathode. The two half cells are connected by a salt bridge which contains an electrolyte which maintains the electrical neutrality.

Answer: Yes

Explanation: Since strong acids react with and use up water molecules, and strong bases do not

Answer:

B.Convection

the movement caused within a fluid by the tendency of hotter and therefore less dense material to rise, and colder, denser material to sink under the influence of gravity, which consequently results in transfer of heat.

Answer:

B.

Explanation:

Answer:

A molecule is the answer.

Answer:

b

Explanation:

The single-stranded regions of DNA are protected during replication by single-stranded binding proteins.

The single-stranded binding proteins are a class of protein found in some living organisms. They bind to single-stranded regions of the DNA during the process of replication, recombination, or DNA repair and protect the DNA from being degraded by nuclease enzymes. In addition to protecting the single-stranded DNAs, they also hinder the single-stranded DNA from premature hardening during replication.

The correct option is b.

Answer:

The number of moles of strontium sulfide produced is:

= 1.663.

Explanation:

Chemical formula for strontium sulfide = SrS

Production of strontium sulfide = 199g

1 mole = 1 moles Strontium Sulfide, which is equal to 119.685 grams

The number of moles of strontium sulfide produced = 1.663 (199/119.685)

The number of moles of strontium sulfide produced is the dividend of the amount of strontium sulfide produced during the experiment divided by the mass of 1 mole.

The set of atoms that must make up the equation's products so that the equation models the law of conservation of mass is 6H and 2N (option B)

The law of conservation of mass states that mass can neither be created nor destroyed during a chemical reaction but can be transferred from one form to another.

The above law suggests that the total atoms of the reactants must be equal to the total atoms of the products

Now, we shall obtain the sets of atoms in the products. Details below:

Reactants:

Since the number of atoms in the reactants are 6H and 2N, then, the number of atoms in products must be:

Products:

Thus, the sets of atoms in the products are 6H and 2N (option B)

Learn more about law of conservation of matter:

https://brainly.com/question/9434062

#SPJ1

Complete question:

See attached photo

The minimum entropy change of the heat-supplying source is -0.87 kJ/K.

In this case, given the initial conditions, we first use the 10-% quality to compute the initial entropy.

S₁ = 1.485  +  (0.1)(5.6865) = 2.0537 kJ/kg K

The entropy at the final state given the new 40-% quality:

S₂ = 1.4337  +  (0.4)(5.7894) = 3.7495 kJ/kg K

m₁ = 0.026/(0.001057   +  0.1 x 1.002643) = 0.257 kg

m₂ = 0.026/(0.001053   +  0.4 x 1.158347)  = 0.056 kg

ΔS + S₁  - S₂  + S₂m₂  - S₁m₁  -  sfg(m₂  -  m₁)  > 0

ΔS + 2.0537 -  3.7495 + (3.7495 x 0.056)  -   (2.0537 x 0.257)  - 5.6865( 0.056 - 0.257)  >  0

ΔS > -0.87 kJ/K

Thus, the minimum entropy change of the heat-supplying source is -0.87 kJ/K.

Learn more about entropy here: brainly.com/question/6364271

#SPJ1

Answer:

C dispersion , dipole and hydrogen bond

Explanation:

Answer:

C dispersion , dipole and hydrogen bond

Explanation:

Give the other guy brainliest!

Answer: It depends equilibrium constant K

Explanation:   You need to to have reaction formula.

If K >> 1 then concentrations of products are much bigger than

concentrations of reactants. If K < < 1, concentration of products is small.

Answer:

**TAKES POINTS** lol just kidding!! heres your answer: basically all compounds and elements are composed of atoms :)

Explanation:

all elements, and compounds, all matter in point of fact, are composed of atoms. In a compound, there are 2 or more different types of atoms present that are chemically bound In an element there is only the one type of atom

Sure, what's the questions and I can get it for you, and if need further assist you.

1. The number of mole of C₃H₈ needed to make 15.5 moles of CO₂ is 5.2 moles

2. The number of moles of O₂ needed is 25.8 moles

The number of mole of C₃H₈ needed can be obtained as illustrasted below:

C₃H₈ + 5O₂ -> 3CO₂ + 4H₂O

From the balanced equation above,

3 moles of CO₂ was obtained from 1 mole of C₃H₈

Therefore,

15.5 moles of CO₂ will be obtain from = (15.5 × 1) / 3 = 5.2 moles of C₃H₈

Thus, number of mole of C₃H₈ needed is 5.2 moles

We can obtain the number of mole of O₂ needed as follow:

C₃H₈ + 5O₂ -> 3CO₂ + 4H₂O

From the balanced equation above,

3 moles of CO₂ was obtained from 5 moles of O₂

Therefore,

15.5 moles of CO₂ will be obtain from = (15.5 × 5) / 3 = 25.8 moles of O₂

Thus, number of mole of O₂ needed is 25.8 moles

Learn more about number of mole:

https://brainly.com/question/23350512

#SPJ1

Complete question:

How many moles of C₃H₈ are needed to make

15.5 moles of CO₂? How much O₂ will be needed?

C₃H₈ + 5O₂ -> 3CO₂ + 4H₂O

Answer:

Have only single bonds.

Explanation:

Hello,

In this case, we need to remember that saturation is a state at which a carbon chain contains no insaturations, that is neither double nor triple bonds such case are alkenes and alkynes, but saturations only which are characterized by the presence of single bonds between adjacent carbon atoms. Such is the case of ethane (CH₃-CH₃), propane (CH₃-CH₂-CH₃), butane (CH₃-CH₂-CH₂-CH₃) and so on.

Best regards.

Answer:

A, B and C are compounds

Explanation:

First of all, I need to establish that when carbon is burnt in excess oxygen, carbon dioxide is obtained as shown by this equation; C(s) + O2(g) ----> CO2(g).

Looking at the presentation in the question, A was said to be heated strongly and it decomposed to B and C. Only a compound can decompose when heated. Elements can not decompose on heating. Secondly, compounds usually decompose to give the same compounds that combined to form them. Compounds hardly decompose into their constituent elements.

Again from the information provided, the compound A is a white solid. This is likely to be CaCO3. It decomposes to give another white solid. This may be CaO and the gas was identified as CO2.

Hence;

CaCO3(s)--------> CaO(s) + CO2(g)